Resin and white metal kit in 1/43rd scale by Marsh. Body is pretty clean, minimal clean-up and a few holes need to be drilled for the roll bar and fuel filler.
Here I have taped the roll bar to the body so I can get an idea of what angle to drill the holes in the body for the supports.
I mounted the chassis to the body to make sure the roll bar would meet the floor and attached the supports to the main bar with CA.
When the CA set, I removed the assembly… Doing it this way pays off in the end since I know it will fit and I won’t have to fiddle with it over a finished body.
Source: http://cs.scaleautomag.com/SCACS/forums/thread/971731.aspx
Johnny Cecotto Andrea de Cesaris Francois Cevert Eugene Chaboud
No comments:
Post a Comment